IDL Explosives Limited adheres to all the regulatory requirements as prescribed under Explosives Act 1884 and Explosives Rules 2008. Our supplies will be made only to one who is a holder of a license to possess the explosives or the agent of a holder of such license duly authorized by him in writing. All deliveries will be made only against submission of indent in form RE-11 as prescribed
Metal Cladding Combinations
The metal cladding process is very versatile as most of the ductile metals can be clad. Metals which cannot be clad readily by conventional methods, eg. Aluminium+Steel, Titanium+Steel can be easily clad by this process. The process is flexible and a wide range of sizes and quantities can be handled as required by users.

The table below shows an exhaustive Metal Combinations chart

Cladding on both sides of a backer metal with the same / different cladding metal is also possible. Certain EXPLOBOND® clad products can be further rolled / extruded into thinner gauges and can be considered when technically feasible and quantities are adequate.

In case your requirement does not fit into the above range, we can find a solution. Please do not hesitate to contact us.
« Back to Metal Cladding Group